Ribbed DP series barrel

New DPM and DP28 ribbed barrels.  These are direct replacements for the originals.  They were modeled off of originals and have been chrome bored to last!  These also count towards 922(r) compliance as ONE US made part.

We offer a few options:

1) ITW - (in-the-white) these do NOT have the gas hole drilled or the gas block pin holes drilled.  They need the gas block installed by a competent gunsmith or home builder and it must be timed to the chamber face/locking threads properly to get proper function.  They are also lacking a finish in this state, so they can be blued, parkerized or painted.

2) Finished:  Customer provides a usable gas block assembly, we will install the gas block on the barrel, clock and pin it in the correct position. Then, we'll hot blue the whole assembly for a uniform finish.

3) DT tanker model:  Only select this option IF:  1) You have a DT gas block you can send us, because we do NOT have a supply of these. 2) If you are ok with your barrel having the DP28/DPM locking slot still present as we did not have special DT only ribbed barrels made due to lack of demand.

Please send gas block to this address as soon as you finish your purchase: 

                              ATTN: Bryan

                              SmgGunsStore,LLC

                              1025 county road 4380

                              Decatur, Texas 76234

NOTICE:  OPTION "2" & "3" WILL BE DELAYED ON SHIPPING AS WE CAN NOT BLUE ONLY ONE BARREL AT A TIME.  WE WILL WAIT TO BLUE THE BARREL(S) UNTIL WE HAVE SUFFICIENT WORK FOR THE BLUEING SETUP.  On the option "3" barrels, we will also have to do a bit of turning, fitting, to make these work once your gas block arrives, so these may take a few weeks to finish AFTER receiving the gas blocks. THANKS.