New DPM and DP28 barrels.  These are direct replacements for the originals.  They were modeled off of originals and have been chrome bored to last!  These also count towards 922(r) compliance as ONE US made part.

We offer a few options:

1) ITW - (in-the-white) these do NOT have the gas hole drilled or the gas block pin holes drilled.  They need the gas block installed by a competent gunsmith or home builder and it must be timed to the chamber face/locking threads properly to get proper function.  They are also lacking a finish in this state, so they can be blued, parkerized or painted.

2) Finished:  Customer provides a usable gas block assembly, we will install the gas block on the barrel, clock and pin it in the correct position. Then, we'll hot blue the whole assembly for a uniform finish.

3) DT tanker model:  Because there is no market for these, we do not offer this option any longer.  We have heard that someone on weaponsguild forums offers this work.  Upon request, we can provide a drawing we made from an original DT barrel to make the modification of one of our ITW barrels easier for you.

Send gas block to:  ATTN: Bryan

                              SmgGunsStore,LLC

                              1025 county road 4380

                              Decatur, Texas 76234

NOTICE:  OPTION "2" WILL BE DELAYED ON SHIPPING AS WE CAN NOT BLUE ONLY ONE BARREL AT A TIME.  WE WILL WAIT TO BLUE THE BARREL(S) UNTIL WE HAVE SUFFICIENT WORK FOR THE BLUEING SETUP.  AN ESTIMATED TIME WILL BE GIVEN WITHIN 24 HOURS OF RECEIVING YOUR GAS BLOCK. THANKS.