New made bayonet for the semi automatic FG42-2 that we produce. They are steel and have been hot b..
Disconnector for the FG42-2. Machined from carbon steel, heat treated and hot blued...
Ejector block and ejector insert assembly for the FG42-2. Laser cut and heat treated ejector insert..
Extractor for the FG42-2 in both 8mm Mauser and 308 Winchester. Machined from tool steel, heat trea..
Extractor pivot pin for the FG42-2 8mm and 308. 0.125" hardened steel pin...
Extractor spring for the FG42-2 8mm and 308. Ready for installation...
Works in either caliber rifle and is made from hardened S7 tool steel then hot blued...
Bushing for the FG42-2 firing pin spring to firing pin interface. Turned from carbon steel and hard..
Retains firing pin spring in the FG42-2 bolt. Turned from carbon steel and heat treated. Hot blued..
Retains firing pin spring plug inside of bolt. Fits FG42-2. Turned from carbon steel and heat trea..
Two of these pins retain the lower trigger housing onto the FG42-2. Turned from carbon steel, heat ..
Clip to retain rear sight drum on the FG42-2. Laser cut from spring steel, heat treated, and hot bl..
Brand new! Wound in Texas by Tactical Spring from a mil spec multi wire. Springs have been cryo tre..
Guide rod for the recoil spring in the FG42-2. Turned from pre-hardened stainless steel and bead bl..
Knurled safety selector knob. Fits the FG42-2. Turned from carbon steel, heat treated and hot blue..
Showing 1 to 15 of 19 (2 Pages)